Motogadget chronoclassic 2 speedo, black

The diameter of 80 mm in relation to a depth of just 22 mm enables an extremely delicate design and new possibilities for integration in the vehicle.

When switched off, a closed, black dial ensures the perfect look: modern, minimalist and timelessly classic at the same time. The digital display, an in-house development by motogadget, consists of a matrix of 512 tiny, super-bright red LEDs and shines through the dial - unique in the aftermarket.

Perfectly readable in direct sunlight, the display has two lines. The top line shows the gear and speed and the bottom line shows the display values, which can be changed at the touch of a button. The illuminated pointer, perfectly illuminated backlighting and automatic brightness adjustment of the matrix LEDs ensure optimum readability even in dark surroundings.

11 indicator lights are invisible when switched off and shine through the dial.

Control lamps

Reserve
Oil temperature / water temperature
Engine control / MIL
ABS / ASR (Plug & Ride only)
Oil pressure
Left indicator
 Indicator right
 High beam
 Neutral
 Universal warning light

Display

Gear indicator
Speed 999 [km/h/mph]
Trip A 999.9 [km/mi]
 Trip B 999.9 [km/mi]
Odometer 999999 [km/mi]
Speed 0-14,000 [rpm]
Oil temperature 0-200 [°C / °F]
Water temperature 0-200 [°C/°F]
Air temperature -20 - 100 [°C/°F]
Oil pressure 0 - 10.0 [bar/psi]
Drive time [h:mm:ss]
Clock
Time 0-100 km/h - 99.99 s
Acceleration 0 - 2.00 [G]
Average speed 999 [km/h/mph]
Maximum speed 999 [km/h/mph]
Maximum speed 20000 [rpm]
On-board voltage 9 - 18 [V]
Fuel gauge 0 - 100 [%]
 

Adjustable warning messages

Oil temperature
Water temperature
On-board voltage
Air temperature
Oil pressure
Tank capacity
Service interval
Speed warning (shift light)

Universal use on all BMW 2-valve carburettor models with motogadget breakout box

Attention: When converting the BMW electrics to a different speedometer, the original charge indicator lamp is usually removed or replaced by an LED.
In this case, a resistor must be fitted instead of the lamp, otherwise the battery will not be charged.
This resistor can be used with all SE wiring harnesses as well as with the original wiring harness.